I Want To Create For
Crafting for Occasions
NEWSLETTERS  |  STORE LOCATOR  |  CATALOGS  |  MY CRAFT FILE  |  PLAID TV

Wood Burned Pendant

By: Cathie & Steve
not yet rated   AT A GLANCE
 
Skill Level: Intermediate
Time:
THIS PROJECT FEATURES THESE GREAT BRANDS:
INSTRUCTIONSREVIEWS

Supplies

PLAID Supplies
  • CCC LRG DENTED RING OX SILVER
  • CCC FANCY TGGL OX SLV/BLK NCKL
  • CCC JUMPRING PCK OX SLV/BLK NK
  • FolkArt ® Acrylic Colors - Bright Baby Pink, 2 oz.
  • FolkArt ® Stains - Oak, 2 oz.
  • Plaid ® 2 in 1 Craft Tool
  • FolkArt ® Artists Pigments™ - Yellow Citron, 2 oz.
  • Mod Podge ® Dimensional Magic, 2 oz.
Find these items in the Plaid Store!
Other Supplies
Wood Disk (any size works - we used a 1.5” disk)
Rubber Stamp – Cherry Blossom Design
Ink Pad
Paintbrush
Thin Paintbrush
Jewelry Pliers (chain nose)
E6000 Glue

Instructions

  1. Ink the rubberstamp.
  2. Stamp the image onto the top of the wood disk. Allow the ink to dry.
  3. Pre-heat the wood burning tool with the skinny tip attached.
  4. Burn the disk by drawing over the stamped image. Hold the tip for a long amount of time to create a deep burn, dragging the tip like a pencil to create a thin burned line.
  5. Add a coat of FolkArt Stain to the front and back of the wood disk. One coat will yield a light color, two or three coats will produce a darker color. Let dry.
  6. Using a thin paintbrush, apply Baby Pink and Yellow Citron paint to the stained disk to highlight the design.
  7. Use the Baby Pink to paint small flower buds and Yellow Citron to make small leaves. Let dry.
  8. Apply an even coat of Dimensional Magic to the top of the disk. Use a pin to pop any air bubbles.
  9. Let dry for 8 hours in a non-drafty place.
  10. Using 2 pairs of pliers, remove a large link from the loop chain.
  11. Apply E6000 glue to half of the large link and glue to the top back of the disk pendant. This will serve as a bail.
  12. Cut a length of chain to fit your neck.
  13. Using pliers attach a clasp to each end of the chain with jump-rings.
  14. Attach the disk pendant to the center of the chain with a jump-ring.
  15. Add more jump-rings to create a longer dangle pendant.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.